Application: Be utilized in all non-metallic materials, organic materials(such as: coatings, colored paints, varnishes, rubber and other products).To evaluate the weather resistance of the products tested, it mainly simulates the damage caused by UV light, condensing humidity and water sprays, which includes color change, gloss loss, chalking, crazing and other strength loss and oxidation.
Corrosion resistance testing of metal surface coatings.
Application:For ferrous and nonferrous metal and metal alloys surface hardness measurement with Vickers and Rockwell scale.
Application:Also know as Contour Measuring Instrument for precise surface profile measurement such as angle,radius,inclination etc.
Application: Analysis of main chemical composition for stainless steel, carbon steel, brass bars, profiles, forged and cast parts.
Application: use three different diameter fittings pressed connect with pipe, manual sealing. Room temperature, use vacuum pump decompress, and holding the Intemal pressure difference between fittings and pipe to be detected.
Application: Measure the plastic pipes(PVC-ufeed pipe, drainage pipe, low pressure feed pipe, low pressure water pipe, core layerfoam pipe,double-wall corrugated pipe,PE water pipe), the shock resistance of plank and plastic products.
Application: It is applicable for wide range of material for tension, compression, bending,shearing and low cycle test.
Application: For hydraulic bursting test.Achieve national standard GB/T5135.20-2010.
Application: Block the fitting entry and connect with test apparatus by flexible hose. Start the water pump to push out the inside air from the air vent outlet. Then close the airvent. adjust the water pump to the tested pressure. No leakage or deformation should bo observed.
Application: For constant hot and cold temperature test.
Application: Fix the fitting on the apparatus, sink in water and input air at pressure.Then adjust the pressure and keep 10s. No leakage should be observed.
Application: Connect the testing pipe and fittings, fix them on the test machines, apply high and low hydraulic pressure for required cycles. No any leakage shall be found.
Application: Connect the test pipes and fittings, fix them on the machine and conduct the vibration test with internal pressure holidng. No any leakage.
Application:For air and hydraulic leakage test with high and low pressure in industrial products.
Application: Test sample both sides connect with 500mm lenath pipe and pressed joint. inpouring water pressure at 1.7MPa and holding, two sides are symmetrical, set a supporting point on both side.
Application: The cold-hot cycling test rapidly alternates between high-temperature and low-temperature environments to simulate temperature fluctuations in actual usage, thereby detecting the fatigue resistance of the crimped connection points.
The temperature range covers ambient to 532°C with an accuracy of ±1°C, meeting testing requirements for extreme high-temperature operating conditions. It supports isothermal, gradient heating (rate ≤5°C/min), and thermal cycling impact modes.
Based on X-ray fluorescence (XRF) technology, it rapidly analyzes elemental composition and coating thickness by exciting characteristic X-rays from coatings without damaging samples. The system enables precision positional alignment for testing complex structural features of press fittings, including curved surfaces and threaded sections
Rapidly cycle between low (under 0°C) and high temperature to detect leakage risks under thermal expansion and contraction stresses. Validate the deformation resistance of press-fit joints and tubing, requiring no plastic deformation or dislodgment after cycling. Accelerated cycling detects material deterioration phenomena.
After inserting pipes into all ends of the fitting, water is injected to observe weepage at each end, fulfilling the client's functional requirement.
